check_aaccli is a Nagios plugin, which checks the health of Adaptec SCSI Raid Controllers (which may identify themselves also as IBM ServeRAID). This is accomplished by using the aaccli command, which must be installed. The plugin checks the health of single disks (S.M.A.R.T) and containers of type "Mirror". Stripes are not supported.
Usually the plugin is called without any parameters:
nagios:~> check_aaccli
OK - no problems (4 disks, 2 containers)
For debugging purposes it can be called with the -v option. It will then output the detailed status of each checked component.
nagios:~> check_aaccli -v
collecting controller informations
calling sudo -S /sbin/aaccli controller list
calling sudo -S /sbin/aaccli open /readonly aac0 : → ...
→ disk show smart /full
calling sudo -S /sbin/aaccli open /readonly aac0 : → ...
→ container list /full
checking controller aac0
checking disk 0:0:0
checking disk 0:2:0
checking disk 0:3:0
checking disk 0:1:0
checking mirror 255
checking mirror 254
OK - no problems (4 disks, 2 containers)
Requirements:
Comments not found