Fixes:
- Not able to establish the vpn tunnel with iphone in IPv4/IPv6 mode.
- Fixed SSL VPN ActiveX certificate expired.
Known Issues and Limitations:
- [CLI]Device is accepting start IP address is larger than end IP address in IPv6 Address pool table
- Device is not accepting mode config pool IPs for a specific range of addresses through CLI
- Not able to change to IPv4/IPv6 dual mode through CLI.
- Unable to login to the device GUI after configuring custom portal as default
- Device is not showing prefix length for IPv6 WAN address in router status and WAN setup page.
- Sometimes TELNET session to the device is not accessible
- List of services of server group are not displaying in CLI show command.
- Device is not showing proper error message while performing ping and trace route when the selected local gateway WAN is down
- Device is showing error "IP subnet conflicting with WAN1" while adding multihoming IP address when WAN ISP type is PPPoE/PPTP
- Opened ports are getting closed when we make changes to other rules in Port Triggering page.
- Device WAN not able to connect with the Windows PPTP server.
- Not able to establish IPv6 SSL-VPN tunnel from java based browsers with java 8 update 20 version.
- Unable to run the FTP traffic from Filezilla client over SSL Port forwarding tunnel in the Windows7 64 bit host
- Unable to establish Port forwarding tunnel from Windows7 64 bit IE9 browser.
- [SSL VPN] tunnels establishment failed for Windows 8.1 64 bit IE11 browser.
- Link detection processes are seen for WAN3 and WAN4 also but device is having only WAN1 and WAN2.
- Observed critical error when we click on trace route option, if ping though VPN tunnel is selected
Comments not found