Overview
- Horizontal stripes noise reduction when changing aspect mode
- Noise reduction when changing signals or inputs
- Slight improvement on HDR mapping accuracy
- Improvement on 3D crosstalk
- Support of SNMP
- Slight improvement on latency when changing signals or inputs
- Improvement on focus with short throw lens when rebooting
- Improvement on other operation problems compatibility
Uploading the System Software
CAUTION: During the update process, do not remove the USB device or turn off the projector.
1. Power off the projector.
2. Make sure no other USB device is connected to the projector before starting the update.
3. Insert the USB storage device containing the update folder into USB port of the projector.
4. Power on the projector. Update process starts automatically.
Note: The ON/STANDBY indicator will blink green and then amber during the update process. The update process takes about 5 minutes to complete.
5. Once the update is complete, the ON/STANDBY indicator will lights up red, and the projector will enter Standby Mode.
6. Remove the USB device.
7. Power on the projector.
Note: After the update, the initial power on takes about 15 minutes to light the laser. During this period, ON/STANDBY indicator will blink green and all the fan will spin at high-speed. During the updating process, DO NOT unplug/power off the projector.
8. Once the projector completely starts and the laser is lit, the update process is complete.
9. Check the current firmware version to confirm that the update has successfully installed.
Note: If the version number is 4.203, the firmware update was successful.
About Projector Firmware:
Install this firmware package and projectors can benefit from higher image quality, improved performance and stability, various fixed issues encountered throughout the unit’s lifetime, as well as several other changes.
Still, if you wish to apply this release, it would be best if you first read and understand the installations procedure; also, perform this task using a fully-charged battery or in a steady power environment (such as the one ensured by a UPS unit), and only after you have familiarized yourself with the update steps.
Bear in mind that, while the firmware is upgrading, it isn’t recommended to use the projector’s buttons, or interrupt the process in any way; doing so can cause serious malfunctions to the device and might even render it unusable.
That being said, if you intend to update to this release, click the download button, get the package and update the firmware version. If not, check back with our website as often as possible so that you don’t miss the update that will boost the performance of your projector.
Comments not found