Enhancements and Changes:
- Updated FW for compliance to the new regulatory EN 300 328 and EN 301 893
- Added device mode.
- No reboot while setting “Internet Setup”, “ADSL Setup” and Setup Wizard.
- Updated PVC quick scan table.
Bug Fixes:
- Port Forwarding: When disable(delete) an Inbound Firewall Rule and then enable(rebuild) it, It will not work,Unless reboot the router
- Diagnostics: Nslookup result is a IPv6 address
- Genie: Genie ReadyShare page cannot open
- QoS: Added a priority for MAC address GUI is error
- Port Forwarding: No warning message when move position is error
- D6300 - no internet access on 5 GHz guest network, DNS IP address must be set manually
- Setup wizard page error when router is connected to PPTP server
- DNS display issue
- Can't visit internet when connection mode is static ip address through setup wizard
- To ping IPv6.google.com in 6 to 4 mode fail after 2 hours
- Recurrence pattern doesn't display fully
- After enabling parental control, advanced page still displays the previous DNS.
- QoS rule of Ethernet LAN port doesn't work
- Sending logs to syslog server not working (Block site log)
- Sending logs to syslog server not working
- Unable to access the wireless settings and Guest settings after updating the NETGEAR Genie app.
- Netgear genie app on apple mobile device has no access to router settings
- Fixed the issue that Genie cannot detect new firmware.
- Fixed the issue that Genie cannot support 5GHz part.
- Warning message is incorrect in port triggering
- USB printer issue
- GUI doesn't auto skip to "Rebooting the router now, please wait…" page when configuring v6 as Fixed
- Connection Status page displays too small to see the buttons in this page in DHCP mode
- Pop up error message when set valid interface ID
- Some issues about GUI - WiFi schedule page
- GUI displays as 'Unknown Error: 1' when upgrading the firmware with incorrect size.
- LAN PC can ping primary WAN IP when plug out WAN wire with DHCP mode and DNS displays abnormally in some cases
- Fixed once traffic meter limit is reached, connection is blocked, disabling TM through NETGEAR Genie won't re-open the connection. Click [Apply] button in router web GUI can make the router reconnect to internet again.
Comments not found