Piklab

Piklab is an open source IDE (Integrated Development Environment) for applications based on dsPIC and PIC microcontrollers.

This application is very similar to the Microchip MPLAB software. A command-line programmer is included.

What is new in this release:

• added support for 18F2XK22/18F4XK22 [patch by Micheal Vrolijk]
• added support for 16F1829 and 16F1507 [patch by Gal Zsolt]
• added support for direct programming for 18F2XK22/18F4XK22 [with help from Micheal Vrolijk]
• fixed crashes in piklab-prog interactive mode

What is new in version 0.15.6:

• added support for 18F14K22 and 18F13K22 [with help from GAl Zsolt]
• added support for 33FJ06GSxxx and 33FJ128MC802
• added icd2 programmer support for 33F devices [with help from Gonzague Reydet]
• fixed issue where gpsim could not be correctly detected
• fixed way of loading hex/cod file in gpsim [reported by Brian Perkins]
• fixed a crash when stepping with gpsim and a recompile is needed
• fixed some asserts while using debugger interface
• removed standalone-file mode to simplify use model
• moved toolchain and programmer selection to project manager
• fixed crash when issuing "stop" command with piklab-prog [reported by Gonzague Reydet]
• added log and replay features to command-line utilities

What is new in version 0.15.4:

• fixed way of getting wine paths
• fixed crash with custom toolchain
• fixed ICD2 debugging for 16F818/819 [fix by David Taylor]
• fixed problem with custom configuration for direct programmers [reported by Santiago Gonzales]
• fixed firmware directory for icd2 debugger in command-line utility [reported by theuschj]
• fixed 18F breakpoints for large addresses [fix by Michael Widlok]
• fixed debugger buttons state after a several-instruction step [reported by Michael Widlok]
• fixed debugger stepping when "OnlyStopOnSourceLine" option is off [fix by David Taylor]
• fixed debugger stepping not updating state correctly in some cases [fix by David Taylor]
• fixed gpsim device detection [reported by Juanma and lsz]
• added basic custom programmer
• much more complete Spanish translation by Santiago Gonzales

Requirements:

• KDE Plasma
• gputils
• libusb
• parport support in the kernel (linux only) for parallel port support
• PikLoops