New Software for GeoLogismiki
SteinP 3DT is a useful software for contacting settlements calculation taking into consideration the influence of nearby footing elements. All calculations are contacted according to the procedure described in DIN 4019 while the stresses calculation is...
StoneC is a software that performs design calculations of vibro replacement. Vibro replacement is an accepted method for subsoil improvement that is achieved with the installation of large columns of coarse backfill material in the ground, using special...
Liquefaction of loose saturated sandy soils under the effect of strong ground motion is a problem that the geotechnical engineer can face in many surveys. LiqIT is a software for the assessment of soil liquefaction potential based on commonly used field...
SteinN Pro is a useful software for contacting preliminary settlements calculation below a rectangular footing. All calculations are contacted according to the procedure described in DIN 4019. SteinN Pro can perform a parametric analysis based on a given...
BLogPro is simple software that will help users to create soil borehole logs specially adjusted for the Geotechnical Engineer. The pages created include the most commonly used input data such as technical log data, stratigraphy data, and laboratory test...
BLogPro is simple software that will help users to create soil borehole logs specially adjusted for the Geotechnical Engineer. The pages created include the most commonly used input data such as technical log data, stratigraphy data, and laboratory test...
SPTCorr is simple software for estimating various soil properties from the Standard Penetration Test blow count. SPT is a widely and most frequently used in-situ test for geotechnical exploration. It is useful in a wide variety of soils, from weak clays...
SPTCorr is simple software for estimating various soil properties from the Standard Penetration Test blow count. SPT is a widely and most frequently used in-situ test for geotechnical exploration. It is useful in a wide variety of soils, from weak clays...
CLiq is an application provides users an easy to use graphical environment specifically tailored for Cone Penetration Test data (CPT and CPTU). The new software addresses advanced issues such as cyclic softening in clay-like soils and thin layer/layer...
SectionMaker is an add-on module for our CPeT-IT software. It provides an easy to use CAD like interface for the creation of 2D cross sections based on the typical geotechnical sections previously defined in CPeT-IT. Features include imports typical...
