New Science Software for Windows 98

CapCoder gives the capacitance in microfarads, nanofarads, picofarads, and tolerance of any capacitor code entered into its input section. CapCoder uses numeric spin-buttons and a combo box so that no typing is required for data...

Resistor Coder gives the resistance in ohms of any resistor color code entered into its input section. Four or five band resistors can be accommodated by this program. This app uses drop-down combo boxes so that no typing is required for data entry....

In Resonator, enter the center frequency plus the inductive/capacitive reactance you desire and press the Calculate button to calculate the necessary inductance and capacitance for L and C...

HF Dipole is good for 1 - 500 MHz, although intended for MF - HF useage. HF Dipole does nothing more than the standard 468/freq (MHz) type calculations. It was written for DOS many years ago and ported to Windows. The output shows the 1/2 wavelength and...

The diplexer is the Joe Reisert, W1JR popularized design discussed under Diplexer Topics on this web site. The user inputs an IF and presses the Calculate button to have the capacitor and inductor values given in pF and uH respectively. The diplexer...

GGT stands for Graphical GenoTypes. A graphical representation of molecular marker data can be an important tool in the process of selection and evaluation of plant material. A computer program was developed that enables representation of molecular marker...

Mapinspect features map comparison, marker highlighting, and graphical display of Pair-wise recombination estimates on the final map. MapInspect features highlighting of a primer-combination or marker name, and marker-friction...

The multiple alignment procedures implemented in MALIGN are close parallels to those used to search for minimum length cladograms. The logic and program commands will be clear to those familiar with programs such as Hennig86, NONA, and PAUP. Alignment...

EngineSim works in two modes: Design Mode or Tunnel Test Mode. In the Design Mode, you can change design variables including the flight conditions, the engine size, the inlet performance, the turbo machinery compressor and turbine performance, the...

TunnelSim solves the continuity equation for a geometry that you specify using sliders and input boxes. The analysis is limited to incompressible, inviscid, one-dimensional flows, and the program warns the user if the diffuser angle exceeds a separation...