Changes:
- Upgrade wireless driver
- Update time policy
- Fixed WDS link rate status
- Fixed Ping utility and WDS UI
Firmware Upgrade Procedure:
- Save the downloaded firmware file to your PC
- Right click on the downloaded file and select Extract All or Extract Here option
- Make sure to remember the location where the extracted file will be saved.
- Log into to the router’s configuration page (default IP is 192.168.10.100)
- Navigate to the Administrator section and click Firmware Upgrade
- Click Browse and in the Upgrade Via Local PC section. Select firmware file (.dat) in the extracted file and click the Upgrade button to proceed.
- Wait until the firmware upload completed and the device reboots.
- The firmware upgrade is completed.
- To finalize the firmware update process you must reset the device to factory default settings. Click the Default button located on the Administrator and Profile Setting page
- Note: Any interruption during the firmware upgrade can damage your device.
About Access Point Firmware:
If you update the Access Point (AP) firmware, your device can benefit from changes that fix multiple issues encountered by wireless clients, correct different user interface problems, add various functionalities, and include support for newly developed protocols.
Before performing this task, we recommend that you read and understand all the installation steps, because there are many AP models and manufacturers available. Each producer strives to make the procedure as simple as possible, but there are cases when it’s anything but that.
It is also advisable that you apply a new access point firmware in a steady power environment (UPS unit will satisfy this need), using an Ethernet cable rather than a wireless connection. The latter can be easily interrupted.
With this in mind, if you wish to apply this version, click the download button and install the package on your access point. Remember to check back with our website as often as possible so that you don’t miss a single new release.
Comments not found