Specifications:
- Intel Z170 Chipset
- SLI – Up to 2-Way + PhysX
- 2 USB 3.1, 6 USB 3.0, 2 USB 2.0
- 4 DIMMs, dual channel DDR4, 3600 MHz+, up to 64GB
- Solid State capacitors
- Form Factor – ATX
- Killer E2400 NIC
- Realtek 8 channel audio + optical out
- 2x M.2 Key M up to 32GB/s
- M.2 Key E
- Replaceable BIOS Chip
- PCI-E Lanes – 16
Features:
- 8 Phase PWM
- 6 Layer PCB
- Onboard Power, Reset, and CMOS Reset buttons
- Isolated Audio traces for better sound clarity
- Onboard POST Code Indicator/CPU Temp Monitor
- Black Nickel CPU ILM
- 300% Increased Gold Content
External I/O:
- 2x USB 2.0
- 6x USB 3.0
- 2x USB 3.1
- 2x NIC (Killer 2400 and i219PHY)
- HDMI 1.4
- Display Port 1.2
- Realtek 8 channel audio + optical out
- CMOS reset switch
Internal I/O:
- 1x USB 3.0 header (2 ports)
- 10x SATA 6G
- 2x SATA Express (uses 4 SATA 6G)
- 2x M.2 Key M
- M.2 Key E
This package contains the files needed for installing the SATA driver. If it has been installed, updating (overwrite-installing) may fix problems, add new functions, or expand existing ones. Even though other OSes might be compatible as well, we do not recommend applying this release on platforms other than the ones specified.
To install this package please do the following:
- Save the downloadable package on an accessible location (such as your desktop).
- Unzip the file and enter the newly-created directory.
- Locate and double-click on the available setup file.
- Allow Windows to run the file (if necessary).
- Read EULA (End User Licence Agreement) and agree to proceed with the installation process.
- Follow the on-screen instructions.
- Close the wizard and perform a system reboot to allow changes to take effect.
About SATA / AHCI / RAID Drivers:
When you install an operating system, SATA settings (be it AHCI, RAID, or IDE mode) are detected from the BIOS. If you want to change from one mode to another after the OS has been applied, appropriate drivers are required.
Bear in mind that if you modify these settings without installing proper files first, the operating system will not be able to boot until changes are reverted or required drivers are applied.
To perform the latter task, get the package, run the available setup and follow the instructions displayed on-screen for a complete installation. Afterwards, perform a system reboot so that all changes take effect, enter BIOS menu, and set the SATA option to the mode that best describes the newly applied drivers.
So, if you intend to modify the SATA settings to the mode described by this release, click the download button, and make the desired changes. In addition to that, don’t forget to constantly check with our website so that you don’t miss a single new release.
Comments not found