SmartRF04Mon is a library used as plug-in in Keil uVision IDE to provide a
interface for "8051" based RF devices from Texas Instruments.
The following Evaluation Boards are supported:
- SmartRF04EB
- SmartRF05EB
- CC Debugger
The following RF SoC Devices are supported;
- CC1110
- CC1111
- CC2510
- CC2511
- CC2430
- CC2431
This Texas Instruments Low-Power RF (formerly Chipcon) driver allows you to debug your application with uVision via the on-chip two-wire debug interface. The two-wire debug interface is supported by TI's SmartRF04EB development kit
Fixes:
- A check on vendor of selected device updated to include both "Chipcon" and "Texas Instruments"
About Debug Driver:
If you install this package, your device will be properly recognized by compatible systems, and might even benefit from new features or various bug fixes.
Please note that, even though other operating systems might also be compatible, we do not recommend you apply any software on platforms other than the specified ones. Doing so might cause the installation to crash, which could even render the device unusable.
When it comes to installing the package, the steps should not be much of a hassle because each manufacturer tries to make them as easy as possible; usually, you must make check for compatibility, get the package, run the available setup, and follow the instructions displayed on-screen.
However, due to the large number of devices out there and the various ways for applying these packages, it would be best if you refer to the installation manual first, to be sure of a successful update.
That being said, click the download button, and apply the present software on your product. Also constantly check with our website to stay up to speed with latest releases.
Comments not found