TP-Link TL-WA901ND V3 Access Point Firmware

450Mbps Wireless N Access Point

- 450Mbps wireless transmission rate, brings smooth wireless N experience
- Supports multiple operating modes: Access Point, Client, Universal/ WDS Repeater, Wireless Bridge
- Easily setup a WPA-PSK/WPA2-PSK encrypted secure connection at a push of the WPS button
- Up to 30 meters (100 feet) of flexible deployment with included Power over Ethernet Injector

Modifications and Bug:

Bug Fixed:
- Fixed the directory traversal security bug.
- Fixed the bug that the LAN getway does not take effect when TL-WA901ND is in Client mode.
- Fixed a display error in the WDS scanning result page.
- Fixed the bug that chromecast cannot work with TL-WA901ND.

Notes: 
- For TL-WA901ND(UN) V3
- Your device’s configuration will be lost after upgrading, which means you need to configure your device again after upgrading.

About Access Point Firmware:

Before you consider downloading this firmware, go to the system information page of the router and make sure that the currently installed version isn’t either newer or matching this release.

Due to the large variety of router models and different methods for upgrading the device, it is highly recommended that you read and, above all, understand the installation steps before you apply the new firmware, even if you are a power user.

In theory, these steps shouldn’t be much of a hassle for anyone, because manufacturers try to make them as easy as possible, even if they don’t always succeed. Basically, you must upload the new firmware to the router through its administration page and allow it to upgrade.

If you install a new version, you can expect increased security levels, different vulnerability issues to be resolved, improved overall performance and transfer speeds, enhanced compatibility with other devices, added support for newly developed technologies, as well as several other changes.

If you’re looking for certain safety measures, remember that it would be best if you perform the upload using an Ethernet cable rather than a wireless connection, which can be interrupted easily. Also, make sure you don’t power off the router or use its buttons during the installation, if you wish avoid any malfunctions.

If this firmware meets your current needs, get the desired version and apply it to your router unit; if not, check with our website as often as possible so that you don’t miss the update that will improve your device.